SoftWall Finishing Systems SW9729667021 Guía de instalación descargar pdf (Pagina 2)

STEP 2: Mount Polystyrene Strips

Mount polystyrene strips directly to masonry walls or

drywall using construction adhesive at the bottom of

the drop ceiling, base of walls and every two feet on

center.

For installation on wood or metal studs, skip to Step

STEP 3: Mount Vinyl Rails

Install vinyl rail extrusions over the polystyrene strips

using construction adhesive. Use 5/8” ﬂat head

screws to secure rails until adhesive cures.

For installation on wood or metal studs, screw vinyl rail

extrusions directly to studs.

STEP 4: Insert Wall Panels

Measure the height of your walls and cut your acoustic

wall panels accordingly using a utility knife. Be careful

not to cut through fabric on the front side.

Slide panel into the top rail ﬁrst, then slide into the

bottom rail.

STEP 5: Tuck Fabric Edges

Once all panels are in place and adhesives have cured,

tuck in the fabric edges along the vinyl rails.

Using the installation roller included, seat the fabric in

the vertical vinyl rails along each edge. Work from top

to bottom using short up and down strokes.

STEP 6: Add Trim (Optional)

Add base board and/or crown moulding (not included)

to complete your space.

Sample Finished Space With Full Panels

Installation Instructions

Full Panel 2-Pack Kit

1 2

Sin comentarios

SoftWall Finishing Systems SW9729667021 Guía de instalación Pagina 2